Archive | Q&A RSS feed for this section
Kitcar_Lotus7_Replica

Q&A Round 3

Welcome to Q&A Round 3… What would you like to know? Leave a question in the comment section below or on our Facebook page.  The Fraser Team will answer ALL questions this round.  Questions close 1st April and will be answered over the month of April. This is your chance to find out what you would […]

Banner_1

Q&A Round 2

Welcome to Q&A Round 2… You wanted us to do it again, so we are!  What would you like to know? Leave a question in the comment section below.  The Fraser Team will answer ALL questions this round.  Questions close 1st October and will be answered over the month of October. This is your chance to […]

Q&A #10

Thank you for all of those who asked questions.  The team had a fun time answering them.  We will aim to do a Q&A like this every couple of months if you think it will be useful/interesting. Let us know by leaving a comment. At random the last for this round… Question 10/10 From our 'It's […]

Q&A #9

At random… Question 9/10 From our 'It's Your Chance' post. Q What kind of engines are avaliable to replace a 4AGE – with what kind of horsepower, and at what approximate cost? Posted by: Andrew | June 09, 2009 at 08:25 PM A If you have the earlier 16V engine then a later 20V engine would […]

Q&A #8

At random… Question 8/10 From our 'It's Your Chance' post. Robbie managed to sneak 3 questions into his comment, so we have answered them all! Q I'm looking to buy a 'pre-loved' Fraser, but finding one with the exact specification I want is difficult because they are all so individualised. So my question to you […]

Q&A #7

At random… Question 7/10 From our 'It's Your Chance' post. Q What is the correct ride hieght for a 1996 live rear axial Fraser and at what locations are the heights measured Posted by: Paul Miller | June 10, 2009 at 08:39 PM A The front is measured at the lower chassis rail, under the […]

Q&A #6

At random… Question 6/10 From our 'It's Your Chance' post. Q What type of welding is used to assemble the chassis components & can these component be purchased sepaerately to save on shipping costsfor welding in this country?regards,Phillip. Posted by: Phillip Potgieter | June 08, 2009 at 10:19 PM A We use low fuming bronze […]

Q&A #5

At random… Question 5/10 From our 'It's Your Chance' post. Q Have you done any cars with a Suzuki Hayabusa powerplant? Any reason it couldn't be done? Would obviously need some sort of adaptor kit to an inline gearbox, but I believe these are available. Posted by: Alfonso Delgardeo | June 08, 2009 at 10:50 […]

Q&A #4

At random… Question 4/10 From our 'It's Your Chance' post.  We also had a response from Stephen, which we have included below our answer. Q Hi there, I have one of the early Frasers (No 15) and want to know what I can do to polish the aluminium bodywork. I've been using a polish (forget the […]